How to remove and install front décor plate
Before you start
⚠️DISCLAIMER
Information in this document is believed to be accurate and reliable. However, the manufacturer does not give any representations or warranties, expressed or implied, as to the accuracy or completeness of such information and shall have no liability for the consequences of the use of such information. The manufacturer is not liable or responsible for any problems arising from the attempted repair. The manufacturer reserves the right to make changes to information published in this document, including without limitation specifications and product descriptions, at any time and without notice. The manufacturer's products are not designed, authorized, or warranted to be suitable for use in applications where failure or malfunction can reasonably be expected to result in personal injury, death, or severe property or environmental damage. The manufacturer accepts no liability for inclusion and/or use of its products in such equipment or applications and therefore such inclusion and/or use is for the customer’s own risk.
⚠️SAFETY INSTRUCTIONS
make sure the roaster is turned off
the power cord has to be unplugged
follow the steps as instructed below
Tools
2 and 3-millimeter hexagonal tool
How to remove front décor plate
1a. Pull out the trier and the drop handle.
The black drop handle is attached by a set screw. Use the 3-millimeter hexagonal tool to remove it.
For the wooden drop handle, just pull it to take it off.
2. Disconnect the touchscreen cable from PCB. Push back the black retaining clip and detach the cable. Ensure the retaining clip is left in place at the connection point.
3. Remove the three front plate screws by using the 2-millimeter hexagonal tool.
4. Slowly remove the front décor plate from the roaster. Take off the front décor plate and place it on a protective surface. Leave the 40-pin cable connected to the screen.
How to install front décor plate
1. Feed the touchscreen cable through the original slots on the roaster and put the front décor plate in its position.
1. Cable through the frontal slot
2. Front décor plate installation
3. Cable through the top slot
2. Install the touchscreen cable into the PCB. Push the black retaining clip and insert the cable (you must twist it to show the blue band of the cable facing up).
You can use a flat head screwdriver to keep the clip “open” while inserting the cable.
Once in position, fasten it by pushing the clip back to its original position.
3. Install three M3 x 6 countersunk screws into the front décor plate by using the 2-millimeter hexagonal key.
4. Install the drop handle and the trier. For a wooden handle, push it through. For a black drop handle install the set screw using the 2-millimeter hexagonal tool.
