Beate Øvland 10/10/22 Beate Øvland 10/10/22

Machine parameters

If you would like to adjust your machine settings, you can access them via Machine Setup on the touchscreen.

1. Bean cooling duration: Duration of increased speed after drop.

2. Bean cooling %: Percentage speed after drop.

3. Bean cooling idle %: Percentage speed while idling.

4. Temperature reading: Celsius or Fahrenheit.

5. Bean cooler light and Window light: Can be turned ON or OFF.

6. Cool. tray warn (BETA): Coming soon.

IMPORTANT. The bean cooling fan is always ON, but can be set to increase in speed when the coffee is dropped.

If you don’t want the bean cooling fan to increase speed after dropping, set the timer to 0 seconds or the fan speed to the same rate as the idling speed.

Beate Øvland 8/18/22 Beate Øvland 8/18/22

How to change: Bean cooler LED light

How to replace a touch screen on your ROEST.

Sections:

Where to buy LED light?

If you are sure your LED-light is broken (you have talked to our Support Team) visit our e-shop to purchase a new one!

buy now

Before you start

⚠️DISCLAIMER

Information in this document is believed to be accurate and reliable. However, the manufacturer does not give any representations or warranties, expressed or implied, as to the accuracy or completeness of such information and shall have no liability for the consequences of the use of such information. The manufacturer is not liable or responsible for any problems arising from the attempted repair. The manufacturer reserves the right to make changes to information published in this document, including without limitation specifications and product descriptions, at any time and without notice. The manufacturer's products are not designed, authorized, or warranted to be suitable for use in applications where failure or malfunction can reasonably be expected to result in personal injury, death, or severe property or environmental damage. The manufacturer accepts no liability for inclusion and/or use of its products in such equipment or applications and therefore such inclusion and/or use is for the customer’s own risk.

⚠️SAFETY INSTRUCTIONS

make sure the roaster is turned off
the power cord has to be unplugged
follow the steps as instructed below

Tools

Parts

Cable ties to re-cable the LED light to the motor bracket.

Instructions

Step-by-step guide:

1. Remove the top plate. You can read how to do it here.

2. Remove the left side panel. Click here to see how to do it.

3. To know where to relocate and fasten the new LED light, you can take a photo of the cable location on the PCB (connector named LED1 on the PCB) and how cables are fastened to the motor bracket.

4. Disconnect bean cooler LED light cable from PCB.

5. Remove the old Bean Cooler LED Assembly. NOTE: if the LED is damaged, disassemble it from the bracket and dispose of it responsibly.

6. Cut cable ties to release LED cable by using the cutters.

CAUTION! take care not to cut through any cables. NOTE: Only cut the number of cable ties required to release that cable.

7. Slide the new bean cooler LED into position. NOTE: if the component does not locate by hand, gently tap the component into place until seated.

8. Plug the cable back into the PCB slot (connector named LED1).

9. Start tying the LED cable into position. Tie the LED cable into the remaining cables along the motor bracket.

Ensure that the cable has been fastened in position with a loop. This is in case the PCB needs to be changed.

IMPORTANT: Ensure that proximity extension cables are not cable tied.

10. Trim the excess from cable ties by using the cutters.

11. Before putting the left side panel and top plate back on the roaster, ensure that there is no excess cable from Bean Cooler LED Assembly that can be squeezed and damaged. IMPORTANT: If there is excess cable when the left side panel is fastened in place, this can cause the cable to become damaged and cause electrical faults in the roaster.